Views: 24 Author: Site Editor Publish Time: 2019-08-12 Origin: Site
13mm shearing machine
13mm shearing machine works Principle
We use a 13mm beveled blade shearing machine, which is a mechanical transmission shearing machine. It mainly uses the electric motor to drive the reciprocating motion of the upper and lower blades to complete the work of the shearing plate. It is a machine with early invention and utilization. It has good practicability, but it is noisy and pollutes the environment, but the structure is relatively simple and easy to repair.
Shearing Motor
Shearing machine wheel
Shearing Machine Blades
Shearing Machine electrical cabinet wiring
Shearing machine rack
Shearing machine operating procedures
Before work
1.1. Before the work, the oil should be injected strictly according to the regulations, and the oil volume should be kept properly and the oil passage should be smooth.
1.2. Check if the fastener is loose, and the operating mechanism and brake are normal.
1.3. Adjust the gap between the upper and lower blades according to the thickness of the sheet.
2. At work
2.1. The shearing machine must be operated by two or more people at the same time. It is strictly forbidden to operate the equipment by a single person. A person must be responsible for controlling the switch. The use of the process should pay attention to the interchange response. The control switch personnel can press the switch after hearing the password of the shearer.
2.2. After the machine is started, wait until the transmission mechanism is running normally. And test the machine without profile several times, confirm that the parts are normal to start cutting.
2.3. The upper and lower blades should be kept parallel during work. Always add a small amount of lubricating oil at the knife edge to keep the knife edge sharp.
2.4. It is forbidden to cut ultra-long and super-thick sheets, and shall not shear hardened steel, high-speed steel, alloy tool steel, cast iron and other brittle materials on the shearing bed.
2.5. Do not cut the sheet material that is not pressed firmly by the binder. The sheet material is not allowed to be sheared. It is forbidden to cut two different materials.
2.6. No objects shall be placed within the moving range of the workbench and the beam. The operation switch shall not be placed on any part of the equipment. Must be placed on the fixed stand on the left side of the shears.
2.7. Always pay attention to whether the running parts, sound, temperature rise, etc. are normal during the work. If abnormalities are found, stop and repair immediately.
2.8. When adjusting the blade or tool setting, pull the power switch and adjust it before commissioning.
3. After work
3.1. After work, it is necessary to inspect, clean the equipment, do daily maintenance work, and switch each operation to the collar. Pull the power switch off to make it tidy, clean, lubricated and safe.