This page contains the configuration parameters for:<\/p>\n\n\n\n
- \n
- Dutch Folding coefficients<\/li>\n\n\n\n
- Coining coefficients<\/li>\n<\/ul>\n\n\n\n
![\"ESA](\"https:\/\/www.harsle.com\/wp-content\/uploads\/2026\/05\/image.png\")
<\/figure>\n\n\n\nThese parameters are used to optimize bending calculations for specific bending methods.<\/p>\n\n\n\n
How to Configure ESA S650 Bending Coefficients Properly<\/h2>\n\n\n\n
Step 3: Entering Dutch Folding and Coining Parameters<\/h3>\n\n\n\n
After opening the Coefficients Corrections page, enter the required values for Dutch Folding and Coining operations. These coefficients are applied to the L.D.C. calculations used during bending.<\/p>\n\n\n\n
The configured values are algebraically added to the standard calculated L.D.C., helping improve bending precision for specialized forming processes.<\/p>\n\n\n\n
Step 4: Rebooting the NC System<\/h3>\n\n\n\n
Once the new coefficient values have been entered, the NC system must be restarted for the changes to take effect.<\/p>\n\n\n\n
Without rebooting the control system, the updated ESA S650 Bending Coefficients will not be fully applied to production calculations.<\/p>\n\n\n\n
Saving and Managing ESA S650 Bending Coefficients<\/h2>\n\n\n\n
Step 5: Automatic Saving of Coefficients<\/h3>\n\n\n\n
The ESA S650 system automatically saves coefficient values whenever the operator exits the Coefficients Corrections page.<\/p>\n\n\n\n
This feature simplifies setup and prevents accidental loss of parameter changes.<\/p>\n\n\n\n
Step 6: Understanding Where Coefficients Are Stored<\/h3>\n\n\n\n
It is important to note that the coefficient settings are not saved within individual work programs. Instead, they remain linked directly to the machine itself.<\/p>\n\n\n\n
This means the configured coefficients will continue to apply across different programs until modified again.<\/p>\n\n\n\n
How to Reset ESA S650 Bending Coefficients<\/h2>\n\n\n\n
Step 7: Restoring Previous Coefficient Values<\/h3>\n\n\n\n
If incorrect settings are entered, operators can easily restore the original values by pressing the [Undo Correct.]<\/strong> key.<\/p>\n\n\n\n
This function reloads the coefficient values that were present when the page was initially opened, allowing operators to quickly recover from setup mistakes.<\/p>\n\n\n\n
Best Practices for ESA S650 Bending Coefficients<\/a> Configuration<\/h2>\n\n\n\n
Keeping a Record of Coefficient Changes<\/h3>\n\n\n\n
Maintaining a written record of coefficient adjustments can help operators track machine performance over time. Recording previous values, material types, and bending results makes troubleshooting easier and supports faster optimization in future jobs.<\/p>\n\n\n\n
Coordinating Coefficients with Tooling Setup<\/h3>\n\n\n\n
Bending coefficients should always be considered together with punch and die setup. Even correctly configured coefficients may not deliver accurate results if the tooling dimensions or installation are incorrect.<\/p>\n\n\n\n
For the best performance:<\/p>\n\n\n\n