Louver punching dies for hydraulic ironworker machine video
You are here: Home » Showroom » Video Gallery » Ironworker and Notcher » Louver punching dies for hydraulic ironworker machine video

Louver punching dies for hydraulic ironworker machine video

Views: 111     Author: Site Editor     Publish Time: 2017-10-31      Origin: Site

Inquire

Video

Features

A hydraulic ironworker machine is a machine tool that integrates various functions such as metal shearing, punching, plate shearing and bending. It has the advantages of simple operation, low energy consumption and low maintenance cost. It is the first choice for metal processing in modern manufacturing. equipment. The hydraulic ironworker machine is divided into hydraulic combined punching and shearing machine and mechanical combined punching and shearing machine.


Technical regulations

1. Before starting the machine, check whether the driving parts of the punching and shearing machine and the connecting screws and pins of each part are loose. Whether the electrical grounding is in good condition.

2. Lubricate all parts before work, and drive for two to three minutes, and then start work without any problem.

3. Overloading is not allowed, and punching and shearing of quenched steel is strictly prohibited.

4. When working, you should wear gloves and labor protection articles, and sandals and slippers are strictly prohibited.

5. When punching and shearing, always refuel the punch to prevent the upper and lower punches from skewing.

6. Pay attention to the safety of your fingers when feeding, especially when the sheet is rushed to the end and the presser foot cannot press the sheet, it is forbidden to punch and cut.

7. When driving, it is strictly forbidden to disassemble, proofread the cutting edge and die. Do not beat dies, cutting blades and other parts with force.

8. Strictly control the specification range of the sheet, and it is strictly forbidden to punch and cut when it is exceeded.

9. The workplace must not accumulate other items and a large amount of flushing materials, and must stop when adjusting and cleaning.

10. After the work is completed, shut down and power off in time, and clean up the site.

Get A Quote
Home
Copyright  2023 Nanjing Harsle Machine Tool Co. Ltd. All rights reserved.